[VB] Gas Cap VEnting problem?

[david raistrick]

> What would cause this? I know the gasket/seal on the gas cap is relatively new, and it is generally pretty tough to close the cap - as it is so tight. It is a rubber one. Without going through my notes - I put on a few years ago. I think these were originally cork, should I go back to the cork style.


get rid of the cheap and common cap that doesn't vent.   it will crush
your tank by vacuum if you run it out a few times....

split bus tanks require a vented cap.

(I dont have a split bus tank anymore, so I can't speak to source.
but they exist - find a used or nos original cap and regasket it.  if
you have your old cap, swap the gasket to it.)