[T2] Is any "glue" needed for manifold to airbox junction tubes
Bob Reuter accessys at smart.netTue Nov 27 03:48:53 PST 2018
- Previous message (by thread): [T2] Is any "glue" needed for manifold to airbox junction tubes
- Next message (by thread): [T2] Is any "glue" needed for manifold to airbox junction tubes
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
I've never used anything but mine have always slide on without any gaps would check and double check to make sure there is no old gasket or imperfection stuck somewhere. if not AFAIK they are still avaliable from bus depot and others and would just get a new set, they are relatively cheap as parts for these old things go. if you can't find any I probably have a pair of lightly used ones in the garage (somewhere) good grief is she 14yrs out of college, dang getting old just like my bus take care Bob On Tue, 27 Nov 2018, MUTS wrote: > On daughter's 75 FI bus, I had to replace the manifold to the left cylinder > head when the mounting stud to the injector failed. The old manifold pulled > right out of the old stiff junction tubes attached at the other end to the > airbox, last replaced 14 yrs ago by a porsche repair shop when daughter was > going to school in Savannah and started stalling at lights/ poor idling due > to these leaking, making the intake air too lean. I have a set of new > ones-Does anyone seal these junction tubes with anything like a coat of > gasket cement? The alignment when dry fitted is not directly in line between > manifold ends and the airbox tube extensions- off maybe an eight on an inch. > I assume the flex of the new tubes will bridge the difference. > > -- > MUTS = Michael's Ultimate Thumb Saver > Oboe, English Horn, Clarinet, Soprano Sax support > > _______________________________________________ > type2 mailing list > type2 at type2.com > https://www.type2.com/lists/type2/listinfo > >
- Previous message (by thread): [T2] Is any "glue" needed for manifold to airbox junction tubes
- Next message (by thread): [T2] Is any "glue" needed for manifold to airbox junction tubes
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
More information about the type2 mailing list