[T2] Radio installation

[Robert Mann]

Just in case it helps: the radio need not be wired thru the ignition
switch.  Mine has always had its own more direct supply.  The minor
drawback is that if you don't remember to switch off the radio you can
drain the battery over many h.

R

On Wed, May 24, 2017 at 7:46 AM, Bob Pratt <ka1dza at verizon.net> wrote:

> Hi all,
> I'm trying to install a radio in Myles, the bus. One of the wires is
> suppose to go to a constant 12 volt supply and another goes to a 12 volt
> terminal that is controlled by the ignition switch.
> I can get 12 volts to the radio, but I can't find a terminal that holds
> the memory.
> Since I recently replaced the old wire harness, there is Nothing on fuse
> 7, the one that is supposed to be used for accessories.
> Also, the 4 way switch fell apart when I pulled the instrument panel. How
> many springs are in the switch? I only found 2 very small ones and 1 half
> inch spring.
> Thanks in advance.
>
> Bob
> _______________________________________________
> type2 mailing list
> type2 at type2.com
> https://www.type2.com/lists/type2/listinfo