[T2] why won't it start

[accessys at smart.net]

RESET

lets try this again with paper and pencil instead of my memory


neg term
yellow wire  - crane
white - from wire harness
black - to double relay


positive term
red wire  - crane
white  -  to fuel shut off relay (not stock)
Black  -  from wire harness.

??? have no Fuel Injcetor trigger??

black wires reversed???

gotta mark these wires better

thanks


On Mon, 8 Jun 2015, Jamie wrote:

> Date: Mon, 8 Jun 2015 17:48:33 -0400
> From: Jamie <jrivers at globalserve.net>
> To: accessys at smart.net
> Cc: type2 at type2.com
> Subject: Re: [T2] why won't it start
> 
> read this again...
> "Black wire on Neg is the double relay and white is the power from ignition 
> that formerly went to fan"
>
> the NEG term on the coil should only have the trigger for the crane... and 
> the trigger for the injectors,
>
> you can't feed the double relay from the NEG term on the coil.. and you can't 
> put power from ignition that formerly went to fan to the NEG term....
>
> I think you wrote this wrong... that white wire with the loom on it sure 
> looks like the trigger to the injectors.. thru the ECU....
> but if that white wire is power from ignition that formerly went to fan ,, 
> then it goes on the POS + terminal..
>
> the black wire that you say goes to the double relay.... IF it does go to 
> term 86c on the double relay,, then it should be coming from the POS + term 
> of the coil..
>
>
>
> ----- Original Message ----- From: <accessys at smart.net>
> To: "Jamie" <jrivers at globalserve.net>
> Cc: <type2 at type2.com>
> Sent: Monday, June 08, 2015 12:23 PM
> Subject: Re: [T2] why won't it start
>
>
>> 
>> near terminal is + far terminal is -
>> Black wire on Neg is the double relay and white is the power from ignition 
>> that formerly went to fan.
>> 
>> distributor has been set 90deg clockwise and still won,t start. in this 
>> photo dist is set at 1TDC and crank, rotor, cap are all lined up.
>