Re: [VB] Re: [T2] Heat riser Plugged SP conversion

["Karl" <aufever@xxxxxxxxxxx>]

>> one gasket of each is the correct way to do it, but the small ones are hard
> > to find...This keeps the flow of the carbon going only one way, and it does
> > not begin to collect in the center of the manifold.
> 
> I think that the flow is maintained by the pressure difference between the
> RH exhaust port and the muffler.  I'd always assumed that the small hole
> gaskets were to restrict flow, but had never figured out why.  Does the
> small hole gasket go on the right or left hand side?
> 
> George Lyle
 
George,
I posted this to the lists and you yesterday. Did you not get it?

''> Hmmm, which are the correct gaskets, the big hole ones or the teeny hole
> ones?  which goes where?
 
One of each: small hole goes on the left, large hole goes on the right.''