[T2] Gas gage weirdness

[T2] Gas gage weirdness

c.dreike c.dreike at verizon.net
Fri Feb 22 13:10:20 PST 2019


I figured it out!!!  Simple as grounding the gauge case.
I pulled the gauge in my 64 from the dash and suddenly it didn't work 
either! I noted that there is a ground terminal on the back and that the 
mounting bracket would also provide ground. Once I added the ground wire 
it worked properly. Amazing.
I went back to my bay gauge and added the ground to the case and the 
gauge now works correctly. Amazing!

Thanks for the input.
Chris
71 Sunroof
64DD Kamper Kit

On 2/21/2019 4:47 PM, c.dreike wrote:
> Started testing my gas gage and sender. The sender worked when I 
> installed it. Currently the tank is very low and the sender reads 
> about 80 ohms. According to The Samba this is about correct. The 
> senders run from about 3-5 ohms at full to about 70-80 ohms at empty.
>
> When connected, both of the gauges I have read full and a little past. 
> The battery voltage is about 11.98. The voltage across the gauges are 
> 6.57 on the original gauge and 7.98 on the reproduction gauge.
>
> On the test bench connected to a bench supply, the original gauge 
> reads full at about 6.5V and the reproduction gauge reads full at 
> about 7.2V. As I reduce the voltage to the gauge, the reading goes 
> down. At 0 volts the gauges read empty.
>
> Per the test specs in Bentley, the gauges should read full at about 
> 12V, battery voltage. Both my gauges peg when attached to full battery 
> voltage.
>
> I have double checked the wiring against the schematics and all looks 
> correct. The circuit looks simple enough. +12V on one side of the 
> gauge. The other side of the gauge connects to the sender (5-80 ohms) 
> and the other side of the sender connects to ground.
>
> I'm an electrical engineer with lots of experience with simple stuff 
> like this and this stuff makes no sense to me. I must be missing 
> something. (Kinda like mistaking the wire stripe colors on the turn 
> signal)
> Anyone have ideas on what I should be looking for or doing 
> differently? I'm stumped. I'm about to build an inverting operational 
> amplifier circuit that would drive the gauge so that it would see 0 
> volts at empty and about 7V at full.
>
> TIA
> Chris
> 71 Sunroof
> 64DD Kamper Kit
> _______________________________________________
> type2 mailing list
> type2 at type2.com
> https://www.type2.com/lists/type2/listinfo



More information about the type2 mailing list