[T2] Zbed

[Bob Pratt]

My Westy bed apparently is not the same as a Z-bed. It was a storage space under the seat that is made out of plywood.

Bob Pratt

> On Dec 5, 2015, at 12:56 AM, MUTS . <muts at verizon.net> wrote:
> 
> 
> I installed a 74 Z bed (Full width, no closet in back) in daughter's 75 bus- it has a part that fits over the wheel cover area, requiring you to drill two bolt holes into that cover and use washers on the tire side. Use lots of urethane (E600?) to seal it into place.  One can make T end bolts out of carriage bolts ground down on 2 sides at cap end and use these with large fender washers on seat inside.
> 
> MUTS  = Michael's Ultimate Thumb Saver oboe, clarinet support
> 93 Chevy Roadtrek 210P
> 78 VW Westfalia Camper
> 
> _______________________________________________
> type2 mailing list
> type2 at type2.com
> https://www.type2.com/lists/type2/listinfo