Re: [T2] vanagon pressure regulator

["Jamie" <jrivers@xxxxxxxxxxxxxxx>]

Yup.. as Dons pictures show.. the nut goes on the front of the tin.. the
starter side... front is the front of the vehicle...

best way to access the front of the engine tin is to slide under the right
side in front of the rear tire.. and look up by the starter... you'll
probably have to pop out the accordian flex tube for the heat ....

I like to drain the tank before I get into these jobs,, it only takes a few
minutes to do that and then you don't get a bath...  then install new hoses
while you're doing the fpr.. and you're good for another 5 years

Jamie Rivers


----- Original Message ----- 
From: "Jeffrey Deltano" <
> . The new pressure
> regulators output has threads on it, so I am trying to visualize how it
> attaches to the tin. Is there a nut on the backside? What is the best way
to
> get access to the back of the regulator?

----------------------------------------------------------------------
    To UNSUBSCRIBE send any e-mail to: type2-unsubscribe@xxxxxxxxx
     To email the admin for list help only: type2-admin@xxxxxxxxx
   For additional commands send any e-mail to: type2-help@xxxxxxxxx
 Donations help keep the list going. http://www.type2.com/donate.html
----------------------------------------------------------------------