Date: Tue, 21 Oct 1997 15:14:26 -0700 From: Jim Thompson <uvx196@juno.com> To: type2@bigkitty.azaccess.com Subject: Distributor Vacuum Hoses - Where do they go? Steve White brought up an excellent question that puzzles some from time to time. Over the years, many a 71-74 Beetle and 71 Bus with Dual Diaphragm Distributors have graced my doors and about half the time the vacuum lines are backwards. So here's the poop: First, take a look at your Vacuum can. On the flat side of the can is a hose fitting - for the larger (4.5mm GREEN) hose. This is the RETARD side. Second, on the cone (or rounded) side of the can is the smaller hose fitting. This uses a 3.5mm hose, usually black. This is the ADVANCE side. Third, look at your 34PICT Carburetor. The fitting on the LEFT side of the carb is for the ADVANCE side of your Vaccum can. Connect appropriately. Fourth, look at your 34PICT Carb again. On the rear (RIR) of the carb should be a fitting up towards, but not on the carburetor top. This push-on fitting is just slightly larger than then one on the side. This is for your RETARD side of your Vacuum can. Connect appropriately with the 4.5mm Green Hose. Fifth, Any other fittings on your 34PICT Carb are for the infamous Throttle Positioner sometimes improperly called a "Decel Valve". The fitting for this jewel is an angled one right at the rear base of the carburetor. Connect the small vacuum hose to it to the Throttle Positioner Diaphragm Fitting. If your Throttle Positioner has two fittings (as original on 71 Buses, 71-74 Beetles), connect another length of 3.5mm vacuum hose from that to the Throttle Positioner Solenoid, usually located in the left side of the engine compartment. If you don't have the Throttle Positioner, cap off all the remaining fittings on your carburetor. If you're running one of those new replacement H30/31PICT carbs, the procedure above is the same as they come with these fittings like their distant 34PICT cousins. Original 30PICT Series did not have the RETARD fitting, except for Beetle Auto-Suck Models - BUT - this fitting was for the Auto-Suck Solenoid, not the distributor because they were still single vacuum models (Actually, the Auto-Suck use a combined vacuum/mechanical distributor similar to the 76-78 Buses). Buses don't have these, right? So use this fitting for your RETARD side of the Dual Diaphragm Can. Timing is usually 5 degrees AFTER Top Dead Center when using a Dual Diaphragm Distributor, give or take a degree or two - no two engine setups or running conditions are the same, so you''' have to fool with with of course. One other thing - Strobe Light at idle speed with the hoses CONNECTED. Sorry, no static timing with these, except to initially set the distributor at 0 TDC, start the engine, then strobiscopically time it after it warms up. I am working on the definitive distributor number application guide for my company website right now for customers to order points, condensors, etc. It will show the Volkswagen as well as the Bosch stamping numbers to properly ID that jewel you may find at the local recycler's yard, information gathered from my collection of Ancient Bosch Books, VW Parts Books and the latest microfilms to also show what is superseded to what and even some "can uses". Should be up by this coming weekend if I continue to burn the midnight oil. Jim Thompson Sherwood Automotive * The Old Volks Home http://www.oldvolkshome.com jim@oldvolkshome.com (916) 221-5342 84 Westy 2.1 * 62 Beetle Sedan * 90 Fox Wagon